![]() Continue to configure the system's parameters as needed.Īfter you have assigned an IP address to the system, you can communicate remotely by running Telnet over an Ethernet network.On the remote computer find a required device and click 'Connect' to access serial port over the network. Repeat steps 2 and 3 on the remote computer that will connect to a serial device. Launch the app and log in with your email and password. Host1(config)#interface FastEthernet slotnumber/0 Download and install FlexiHub both on the local and remote computers. Use an IP address valid for the system.Įnter configuration commands, one per line.Substitute the slot number where the SRP module is located for the slotnumber variable.Set an IP address on the Ethernet interface:.The system is now in Privileged Exec mode. Tool for transport of asynchronous serial devices over UDP/IP. The RFC2217 protocol is an extension to telnet and allows changing communication port parameters. It lets you share a serial port through a network. Enter the enable command at the User Exec prompt. sercd is an RFC 2217-compliant serial port redirector.When your console is ready to communicate with the system, power up the system (see Chapter 6, Powering Up the System), and set an IP address for the system. Note: Direct access through the RS-232 serial port allows you to monitor the system as it boots. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |